We are running some 7606 boxes using MPLS, however when we check ;
sh int te 3/2 accounting
Protocol Pkts In Chars In Pkts Out Chars Out
IP 3546160 3748935104 312 47011
CDP 3 1275 2 954
MPLS 0 0 1339120 1474758550
We would expect Pkts In to be MPLS as well, since MPLS traffic is also traversing through the router (you might argue that the packets in are being seen IP because popping would have occured, but this doesn't apply to traversing traffic).
We see this on all our boxes on mpls enabled interfaces. You guys think this is something cosmetic, or are we misreading something?
Seen on a couple of 7606's with SUP7203BXL and IOS 15.1S4
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...