Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SNMP monitoring for EoMPLS virtual circuit

I am looking to implement SNMP-based monitoring of an MPLS layer-2 tunnel. The desired result would be the same as the output from the following command:

"sh mpls l2transport vc"

I have configured the router to generate SNMP traps based on LDP changes, but this is not specific to the status of the EoMPLS tunnel.

Thanks in advance.

1 REPLY

Re: SNMP monitoring for EoMPLS virtual circuit

Polling to these MIB values would have your task accomplished.

1) VC status <--> cpwVcOperStatus

2) If you need outbound staus <--> pwVcInboundOperStatus

3) Inbound status <--> cpwVcOutboundOperStatus

And here is the link for list of MIB objects for L2VPN.

http://www.cisco.com/en/US/products/ps6441/products_configuration_guide_chapter09186a00808194e1.html

HTH-Cheers,

Swaroop

141
Views
0
Helpful
1
Replies
CreatePlease to create content