Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

tag-switching on 6500 interface vlan

Can I use the "tag-switching" command under interface vlan?

My PE is also a CE. The PE is a 6500 connecting to multiple 3750 stacks using multiple vlans. Should I use the "tag-switching" command under each interface vlan, or under the trunk ports connecting to the 3750 stacks?

Thanks

5 REPLIES

Re: tag-switching on 6500 interface vlan

Dear,

I can not understand your case 100%, how is you device acting as PE and CE in the same time!! How! Why!

If you are in seperation issue you can use VRF-Lite.

more details about you case will be good.

Best Regards,

Mounir Mohamed

New Member

Re: tag-switching on 6500 interface vlan

Sorry my question was meant for more advance engineers that will understand it. Thanks.

Re: tag-switching on 6500 interface vlan

Regardless I?m advanced Engineer or NOT, I believe it?s not your business, you MUST be grateful for anybody waste at least 30 seconds trying to help you

You have to be advanced engineer to be able to post advanced questions that meant for advanced engineers, (CE/PE).

Also if you are advanced engineer why did you come and post questions, but really I?m sorry to waste my time to replay on a post for someone doesn?t appreciate anything ,BTW the forum opens for all professionals and unprofessional users, I don?t care I hop you find someone help you.

Best Regards,

Mounir Mohamed

Re: tag-switching on 6500 interface vlan

I hope you are doing a CsC scenario where your PE is a CE and PE at the same time.

Whatever the case, you will have to enable label switching on the Vlan Interface, and not the trunk, as to enable MPLS on an interface it should have a valid IP configured on it. And hence you may not be able to use the label0-switching on the trunk.

HTH-Cheers,

Swaroop

New Member

Re: tag-switching on 6500 interface vlan

Thank you. That is what I was looking for.

135
Views
0
Helpful
5
Replies
CreatePlease to create content