I got the network as in the picture. I need that traffic for customer-1 devices flows through the blue tunnel and from the customer-2 through the red tunnel. I know how to make tunnels on PE-1 and PE-2, but I can't find out how to devide traffic flows from different VPNs.
And on the connected physical interface. You need to map the ACL with the specific permits for the different tunnels.... Also you can have the dynamic routing protocol eigrp/ospf/rip to advertise your LAN subnets from cust 1 and cust 2. If the PE1 knows the route to reach PE2 it will form the tunnel and vice versa. You can restric the blue one to the red by acl and vice versa. I hope you understood the scenarion.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...