Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Terminology Legacy / MQC FRTS???

In case of FRTS when we apply the shaping parameters, for the specific traffic-class and this class is called under the #map-class frame-relay _______ .

What is the terminology used for this tech, it comes under legacy FRTS/MQC-based FRTS??

Sample config:

----------------------------------

class-map TEST

match protocol http

policy-map TEST

class TEST

class class-default

shape average 1024000

shape adaptive 512000

int se1/0

service-policy out TEST

----------------------------------

class-map TEST

match protocol http

policy-map TEST

class TEST

class class-default

shape average 1024000

shape adaptive 512000

map-class frame TEST1

service-policy output TEST

int se0/1

frame-realy interface-dlci 402

class TEST1

----------------------------------

what is the terminology used for them, since both are achieving the same?

Thanks,

Dara

3 REPLIES
Hall of Fame Super Silver

Re: Terminology Legacy / MQC FRTS???

Hello Dara,

the first example is Modular QoS based.

In the second one you are using legacy FRTS just to reference to a service-policy that is again Modular QoS.

This second example could be defined an hybrid legacy FRTS/Modular QoS.

I think in the second example you would need frame-rel traffic-shaping command under se0/1 but this is a detail.

Hope to help

Giuseppe

New Member

Re: Terminology Legacy / MQC FRTS???

Hi,

The router says is terming the second one as GTS.

!

class-map match-all BGP

match protocol HTTP

!

!

policy-map SHAPE

class HTTP

class class-default

shape average 1000000

shape adaptive 512000

!

R2(config-if)#do sh run int se 2/0

Building configuration...

Current configuration : 546 bytes

!

interface Serial2/0

description FRSW

ip address 10.10.24.2 255.255.255.0

encapsulation frame-relay

serial restart-delay 0

no dce-terminal-timing-enable

no clns route-cache

frame-relay class FRTS

frame-relay map ip 10.10.24.4 204 broadcast

no frame-relay inverse-arp

end

R2(config-if)#frame traffic-shaping

Generic traffic shaping commands must be removed before enabling frame-relay

traffic shaping.

AS you can see the interface level frame-relay traffic-shaping isn't accepted when we configure this.

Hall of Fame Super Silver

Re: Terminology Legacy / MQC FRTS???

Hello Dara,

so the second example could be regarded as a GTS case.

Actually, GTS was available for non FR interfaces with commands like traffic-shape given in interface config mode.

This is interesting I had never used this variation on FR interfaces : or legacy FRTS or Modular QoS.

Best Regards

Giuseppe

272
Views
0
Helpful
3
Replies
CreatePlease to create content