MPLS TED is stored in the same database of IGP (i m considering OSPF). You will have to look under the corresponding LSA type. In case of OSPF as IGP, MPLS TE information are propagated through the area using Type 9 Opaque-Area scope LSA.
You can view this information using "show ip ospf database opaque-area".
Type 9 LSA contains three extra attributes - Admin Metric (TE metric, default equal to IGP Metric), Affinity Bits, Maximum Bandwidth available and reserved. CSPF takes these additional three attributes and computes ERO in case ERO is not defined explicitly under tunnel or validates the ERO defined explicitly.
IntroductionPre-requisite: Caveat :When IPXE Boot could be done : IPXE Boot :Ipxe boot using DHCP Server :
iPXE boot in ASR9K
Migration recommendation document for Cxr to Exr.
This document applies to NCS5500 and ASR9000 routers and has been verified as such.
traditional ECMP or equal cost multipath loadbalances traffic over a number of available paths towards a destination. When one path fails, the traffic gets r...
Hi community,I just wanted to share my findings about accesing to ACL counters by SNMP on ASR9000/XR.
Searching on Internet I found the section ACL Counters Using SNMP in the IP Addresses and Services Configuration Guide but I didn't found any inf...