Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Unidirectional VCCV

Dear all,


I have the following simple scenario:


PE1 [7609S (IOS 15.2(4)S1)] – P [7609S (IOS 15.2(4)S1)] – PE2 [ME3600X (IOS 15.3(1)S)]


I configured an RSVP-TE LSP between PE1 and PE2 and a pseudowire on top of it. The pseudowire comes up and traffic between both ACs seems to properly work, even though I have some pending tests to run, yet. The strange thing is that when I run VCCV with “ping mpls pseudowire” (it happens both with ipv4 and router-alert options), ping works from PE1 to PE2, but always fails from PE2 to PE1. May you suggest a reason for this behavior or what you would try to do? I already tried to unconfigure and reconfigure and to change the servicice to a point to point VPLS, but nothing changed.


Thanks in advance


Regards


Octavio

2 REPLIES

Unidirectional VCCV

Dear Octavio,

Just shooting in the dark, is the te-tunnel configured from PE2 to PE1 as well please?

Are you using “preferred-path interface” in the pw-class to direct the PW over the te-tunnel on both ends please?

adam

adam
Community Member

Unidirectional VCCV

Thank you very much, Adam, and sorry for my late response.

Finally we found that it was a bug: CSCth41901. It only affects VCCV. As soon as I mentioned the problem to my local Cisco contact he told me to take a look at it. I suppose it's not the first time that he found this problem.

Thanks a lot for your help.

Octavio

441
Views
0
Helpful
2
Replies
CreatePlease to create content