I am having some difficulty getting traffic into a TE tunnel using static routes.
the architecture is PE to PE via ethernet. i have a single route that comes in via a subinterface which is in a vrf, when i put in a static route i get no traffic coming back. if i use the auto-route announce feature everything works, but i only want this vrf to go down the tunnel. the config on one end is as follows:
this would only work, if the Loopback is configured as /24, otherwise the LIB would not contain a suitable entry and hence no label could be found. This is what I meant, but did not express to clearly.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...