I would like to know various types or mode of VPLS.
As per Cisco standerds its: Port mode and VLAN mode.
Now I would like to know if I can use the PE interface connected to CE as a trunk interface and carry all customer VLAN via that port? Instread of creating multiple subninterfaces of the interface and put them on different instances or VPLS instances?
Is there any good document, site or blog that shows various VPLS deployment mode along with VPLS redundancy scenarios?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...