Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VPLS on 6500

Hi

Please help me, I would like to setup VPLS on two routers (6504) with the following modules and Advanced-Enterprise version 15 IOS. Anybody knows whether this feature is supported or not. If not, what is my minimum requirement for supporting VPLS.

 

6504# show module

Mod Ports Card Type                              Model              Serial No. 
--- ----- -------------------------------------- ------------------ -----------
  1    2  Supervisor Engine 720 (Active)         WS-SUP720-3BXL     SAL134322F9
  3   24  CEF720 24 port 1000mb SFP              WS-X6724-SFP       SAL1219PUZU
  4   48  48-port 100FX SFP Ethernet Module      WS-X6148-FE-SFP    SAL1216N2QD
  

<<... output omitted ...>> 
                                                                               
Mod  Sub-Module                  Model              Serial       Hw     Status 
---- --------------------------- ------------------ ----------- ------- -------
  1  Policy Feature Card 3       WS-F6K-PFC3BXL     SAL134325LA  1.11  Ok     
  1  MSFC3 Daughterboard         WS-SUP720          SAL13421LZN  4.0    Ok     
  3  Centralized Forwarding Card WS-F6700-CFC       SAL1218PC9H  4.0 Ok     

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi,For VPLS, the access

Hi,

For VPLS, the access facing line card (where the CE will be connected) can be any LAN cards. But the core facing line card where label imposition/disposition happens should be a WAN card like ES, ES+, SIP/OSM etc.

Since it is a setup between 2 devices, you can try EoMPLS (port based) with this setup. You can enable xconnect on the port connecting to CE router.

-Nagendra

1 REPLY
Cisco Employee

Hi,For VPLS, the access

Hi,

For VPLS, the access facing line card (where the CE will be connected) can be any LAN cards. But the core facing line card where label imposition/disposition happens should be a WAN card like ES, ES+, SIP/OSM etc.

Since it is a setup between 2 devices, you can try EoMPLS (port based) with this setup. You can enable xconnect on the port connecting to CE router.

-Nagendra

45
Views
0
Helpful
1
Replies