Im trying to create MPLS VPN for my ADSL subscribers .
I'm sending the vrf config. from the radius and On the radius debugs I can see that see that configuration is sending correctly to the router , but on the router Virtual access interface not configured for vrf forwarding .
The tf:rd is configured on the router
07A8 NAS-Port-Type = Virtual
07A8 Service-Type = Framed-User
07A8 NAS-IP-Address = 172.16.120.1
07A8 Sending Code=2, Id=23 to 172.16.120.1
07A8 Profile = "ADSLPPPoE"
07A8 Cisco-AVpair = "lcp:Interface-config= ip vrf forwarding mpls-test2"
Then what if I have multiple VPN's , For each I have to create a loopback interface or what ? . Is there is anyway without adding on virtual template ? . The idea is i don't want to make too many virtual template for differenet VPN services .
I created one Loopback interface and this vrf to that .
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...