We have a CE router connected to PE router. The CE router is connected via 2 links to the PE router, because we need to create two VRFs on the PE for the traffic coming from the CE to separate the traffic, so we have one vrf per link. We are running OSPF between CE and PE.. Now we need to further separate the traffic up to the CE, so Im thinking of using the VRF lite on the CE.. Can MPLS work with the VRF lite, and how to map the VRF lite VRFs on the CE to the MPLS VPN on the PE?
VRF Lite and MPLS-VPN act independently so they can work independently. And there is no specific need for mapping. If link is for VRF A on PE so you can make it part of vrf A in CE as well. Both VRFs are independent of each other.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...