I have a connection point to point on subinterface between PE and CE and use EBGP as routing protocol. The CE are router Cisco7609 and on the subinterface i apply "ip vrf forwarding WAP". Inside this vpn / vrf that I defined before I want to do pbr, so to route the traffic based on the source Ip address. I cannot use the "vrf select" because it is not supported on this platform. So I would like to know if I can do pbr on this subinterface and how can I do it, just only configuring the "ip policy route-map WAP" under the same sub interface where I confgure ip vrf forwarding?
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...