Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Vrf lite and PBR on the same sub interface

Hi,

I have a connection point to point on subinterface between PE and CE and use EBGP as routing protocol. The CE are router Cisco7609 and on the subinterface i apply "ip vrf forwarding WAP". Inside this vpn / vrf that I defined before I want to do pbr, so to route the traffic based on the source Ip address. I cannot use the "vrf select" because it is not supported on this platform. So I would like to know if I can do pbr on this subinterface and how can I do it, just only configuring the "ip policy route-map WAP" under the same sub interface where I confgure ip vrf forwarding?

Thanks

Ira

1 REPLY
Silver

Re: Vrf lite and PBR on the same sub interface

Use the route map as a noraml thing.

To match the all the ip address there should not be any match statement in the route map.

326
Views
0
Helpful
1
Replies