I have a connection point to point on subinterface between PE and CE and use EBGP as routing protocol. The CE are router Cisco7609 and on the subinterface i apply "ip vrf forwarding WAP". Inside this vpn / vrf that I defined before I want to do pbr, so to route the traffic based on the source Ip address. I cannot use the "vrf select" because it is not supported on this platform. So I would like to know if I can do pbr on this subinterface and how can I do it, just only configuring the "ip policy route-map WAP" under the same sub interface where I confgure ip vrf forwarding?
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application Engineered...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?
Cisco Software Manager Server
This document describes the programmatic interfaces, RESTful APIs, which are supported by Cisco Software Manager Server (CSM Server).
CSM Server supports a set of finite RESTful APIs. The fir...