i came across this weird issue and can't seem to find out what's wrong yet, figured i'd get opinion from u guys outhere.
Pls refer to the topology. Router5 link to Router3 is shutdown, forcing packets to route via Router1 btw router3 & router5. Now, when i do a traceroute from router1 (src: loopback100 - 126.96.36.199) >router5 (loopback100 - 188.8.131.52) i seem to get timeout when hitting router1. However, when i use the "traceroute mpls ipv4" i have no issues, and the lsp path is good. I have also tested from router1 to router5 (since it's directly connected) but it gets timedout as well. Pls refer to the attached configs and some traceroute results at the end of the "show run".
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...