In the following example, precedence 6-7 traffic is given strict priority over all other traffic (which may cause starvation). To give precedence 4-5 traffic 50 percent of the remaining bandwidth and precedence 0-3 traffic the remaining 50 percent, follow the steps below.
Router(config-cmap)# match mpls experimental 0 1 2 3
You can also configure this example using two class-maps and then use the class-default to include all other traffic. It is also possible to configure more than 4 precedences in a single class; however, it requires the use of additional match commands.
Next, attach all three classes to a policy map. If none of the classes is a priority class, the maximum number of classes configurable, including the class-default class, is seven. When class-default is not specified, at least 1 percent must be allocated to this class.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...