Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

why con't setup tunnel between PEs?

hi,i have a problem about multicast for mpls vpn.

ce1-Pe1-P-Pe2-Ce2.

at the core use ssm .but i don't know how to config P.the configuration of Pe:

ip multicast-routing

ip vrf a

rd 100:1

route-target both 100:1

mdt default 232.0.0.1

ip multicast-routing vrf a

ip pim ssm default

the configuration of P:

ip pim ssm default.

but display of the PE:

sho ip pim vrf a nei

only have the interface connect with CE .

why don't setup PEs ?

4 REPLIES
New Member

Re: why con't setup tunnel between PEs?

i want to know how to config the P.thans !

New Member

Re: why con't setup tunnel between PEs?

P-config:

ip multicast-routing

ip pim ssm default

Interface config:

ip pim sparse-mode (on all relevant P and PE interface)

You might also need to enable 'address-family ipv4 mdt' on P/PE, dependent of HW/SW

A verification: show ip pim neigh on PE should show P-router as neigbour

New Member

Re: why con't setup tunnel between PEs?

i try to it.it maybe unused.thanks a lot!

New Member

Re: why con't setup tunnel between PEs?

thank you very much!i have make it well.

148
Views
0
Helpful
4
Replies