Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

A %C7200-3-PACONFIG:Exceeds message is displayed on a Cisco 7200 series router

Core Issue

For a Cisco 7200 series router or Cisco 7200 VXR router that has an NPE-225,  NPE-200, NPE-175, NPE-150, or NPE-100 installed, one or more of these error messages may be displayed when the bandwidth points exceed the system  limit:   

%C7200-3-PACONFIG:Exceeds 3 high speed port adapters

%C7200-3-PACONFIG:Exceeds 5 high/medium speed port adapters

%C7200-3-PACONFIG:Exceeds 800 aggregate port adapter bandwidth points

For a Cisco 7200 VXR router that has an NPE-400, NPE-300, or NSE-1 installed,  one or more of these error messages may be displayed when the bandwidth  points are exceeded on the buses:

%C7200-3-PACONFIG:Exceeds 600 bandwidth points for slots 0, 1, 3 & 5

%C7200-3-PACONFIG:Exceeds 600 bandwidth points for slots 2, 4 & 6

%C7200-3-PACONFIG:Exceeds 600 bandwidth points on both odd & even numbered slots

Resolution

If any of the previous messages are displayed on a Cisco 7200 series router, the port adapter configuration must be changed in order to eliminate the error messages.

For guidelines and bandwidth point values for port adapters and I/O controllers, refer to the Bandwidth and Bandwidth Point Requirements section of Cisco 7200 Series Port Adapter Installation Requirements.

Bringing the hardware configuration into compliance with these guidelines will eliminate these messages.

Version history
Revision #:
1 of 1
Last update:
‎06-22-2009 04:46 PM
Updated by: