Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

could someone tell me how to detect the number of the switches in a layer2 network using some commands.

could someone tell me how to detect the number of the switches in a layer2 network using some commands.

cdp can do it,but if you don't have cdp enabled,what should you do.

maybe using show int trunk,and show mac-address-table could do it also,but i think it is a little stupid...

Version history
Revision #:
1 of 1
Last update:
‎01-29-2010 12:30 AM
Updated by:
 
Labels (1)