Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Executing "show" Commands in Global Configuration Mode

This Reader Tip by Tahir Javed explains how to execute "show" commands in Global Configuration mode.

Just type "Do" in start of that privilege mode command and press Enter. It will display as it is output as you can see by executing it in enable privilege mode.

For example..

"router(config)#do show ip int brie"

Version history
Revision #:
1 of 1
Last update:
‎11-04-2009 06:26 AM
Updated by:
 
Labels (1)