Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

How to enable the 10-Gigabit Ethernet and Gigabit Ethernet SFP ports of a SupV in a Catalyst 4500 Series Switch

Resolution

Issue these commands to enable the 10-Gigabit Ethernet and/or the Gigabit Ethernet Small Form-Factor Pluggable (SFP) uplink ports:

Switch#configure terminal
Switch(config)#hw-module uplink select {tengigabitethernet|gigabitethernet|all}

Note: On a Catalyst 4510R Series Switch, if you enable both the 10-Gigabit Ethernet and Gigabit Ethernet SFP uplink ports, you must re-boot the switch. On the Catalyst 4503, 4506, and 4507R Series Switches, this capability is automatically enabled.

Port type

1000 TX

Version history
Revision #:
1 of 1
Last update:
‎06-22-2009 03:40 PM
Updated by:
 
Labels (1)