06-18-2009 03:59 PM - edited 03-01-2019 03:44 PM
If you can access the switch through the web interface, refer to Restart or Reset the Switch section of the document User Guide for the Catalyst Express 500 Switches.
If you are unable to access the switch through the web interface, perform this procedure:
Unplug the power cord from the switch.
Hold the setup button while you plug back in the power to the switch.
Wait until all LED indicator lights turn amber, and then release the button.
When a switch port LED blinks green, connect your PC to that port. The port LEDs on your PC and the switch blink green while the switch configures the connection. This takes about one minute.
Pull up the browser, and select either Erase system configuration item and click Submit.
The switch is now set back to the factory default configuration. Proceed with the initial setup procedure again.
Enter the network settings.
Click Submit to save changes, and finish the basic configuration.
Apply the Smartports roles. This is a very important step if you plan to configure trunk or voice ports. By default, all ports are set up as access ports that belong to VLAN 1.
Note: By default, the switch is set up to VLAN Trunking Protocol (VTP) transparent mode. Therefore, all VLANs should be added using the Graphical User Interface (GUI). Name the voice VLAN Cisco-Voice. If you use a different name, it is not recognized as a voice VLAN by the switch.
Thanks for you Co-Operation,
but i have a switch, when i plugged the power cord, for a moment (system and alert leds blink orange, but setup led blinks green), and then (system led only blinks green and others off).
all ports not working (no indication leds blinks when any device conected to these ports"down and uplinks").
when i was trying to reset the switch by this way i reach the step two and then no leds blinks (for the ports, or setup led).
please, advice me how to solve this issue, and what is the problem?
Thnaks
Omar mahmoud
I've already tried to follow this steps, but when I Pulled out my brwoser, nothing appeared to me.
Why could be the reason for this? There's another way to reset the Switch?
Thanks
Amanda SIlva!
I managed to help myself even though I have windows 7.
Following Cisco's instructions step by step, but with a small modification.
In the step where we expect to get a dynamic IP address "Obtain an IP address automatically"
in advance you set a fixed IP address that you expect: 10.0.0.2 255.255.255.0 (this is all that is needed).
If you do it after you have already connected to the switch, thing does not work, you must do it earlier
while PC is not connected to the switch.
To me it worked I hope it will help you.
on windows 7/8/8.1 you have to disable apipa first:
That helped, thank you
This helped out big time. Thank you!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: