Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Route is missing from the routing table due to enabled synchronization

Core Issue

A Border Gateway Protocol (BGP) router with synchronization enabled will not install an internal Border Gateway Protocol (iBGP) learned route into its routing table if it cannot validate those routes in its Interior Gateway Protocol (IGP) routing table.

Resolution

To resolve this issue, turn off synchronization by issuing the no synchronization configuration command under the router BGP configuration.

For additional information, refer to the Unable to Announce iBGP-Learned Routes section of Troubleshooting When BGP Routes Are Not Advertised.

Valid Route to BGP Next Hop

Valid route to next hop exists

show ip bgp {network mask}

Prefix / network exists, learned by iBGP NOT marked received only

739
Views
0
Helpful
0
Comments