Router cannot see the NME Module
show diag shows that module is inserted into the router, but show ip int brief and show interface doesn't show the integrated-service-engine interface
Slot 2:
Integrated Service Engine-2 Port adapter, 1 port
Port adapter is disabled deactivated
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware Revision : 1.0
Part Number : 73-11062-02
Top Assy. Part Number : 800-28761-03
Board Revision : A0
Deviation Number : 96143
Fab Version : 01
PCB Serial Number : FOC12210M0N
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Product (FRU) Number : NME-WAE-522-K9
Version Identifier : V03
CLEI Code : IPUIA6SRAA
Solution
The gateway should be running 12.4.22T train image (example: c3845-adventerprisek9_ivs_li-mz.124-22.T.bin)
Step By Step Instructions to Configure Integrated Service Module
Step#1
interface Integrated-Service-Engine2/0
ip unnumbered GigabitEthernet0/0.433
service-module ip address 10.4.33.99 255.255.255.0
service-module ip default-gateway 10.4.33.1
no keepalive
!
ip route 10.4.33.99 255.255.255.255 Integrated-Service-Engine2/0
Step#2
cvp-3845#service-module integrated-Service-Engine 2/0 status Service Module is Cisco Integrated-Service-Engine2/0 Service Module supports session via TTY line 130 Service Module is in Steady state Service Module heartbeat-reset is enabled Getting status from the Service Module, please wait.. Cisco Wide Area Application Services Software 4.0.17 (b14 Feb 27 2008 21:55:04) Restarted at Wed Aug 2 00:00:41 2006
Step# 3
https://10.4.33.99:8443 with the user name admin and the default password is "default