Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

User Received "AIM-IPS-K9:PSE_HW-1-PKT_ERROR" on boot-up

Introduction:

This document is created from user discussion.

Core Issue:

When an AIM-IPS-K9 is installed, a router displayed following message as a part of its boot-up process.

Cisco 3845 (revision 1.0) with 221184K/40960K bytes of memory.

Processor board ID FCZ133670YY

2 Gigabit Ethernet interfaces

1 terminal line

1 Virtual Private Network (VPN) Module

1 cisco ips sensor(s), ips monitoring on slot O

DRAM configuration is 64 bits wide with parity enabled.

447K bytes of NVRAM.

250880K bytes of ATA System CompactFlash (Read/Write)

*Feb 11 12:52:17.347: %PSE HW—1—PKT ERROR: preparing paktype of SM CONTROL PACKET

*Feb 11 12:52:44.451: %VPN MW—6—INFO LOC: Crypto engine: onboard O State changed to: Initialized

*Feb 11 12:52:44.455: %VPN MW—6—INFO LOC: Crypto engine: onboard O State changed to: Enabled

 

Solution:

This message will occur when AIM-IPS-K9 installed and its cosmetic message only. There is no impact to the AIM-IPS-K9 or router .No workaround is required.

For more detail, please check CSCsq24774

https://tools.cisco.com/bugsearch/bug/CSCsq24774

Document source:

https://supportforums.cisco.com/discussion/12103281/cisco-3845-error-pse-hw-1-pkt-error-preparing-paktype-sm-control-packet

120
Views
0
Helpful
0
Comments