Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

vsat communication on cisco router through c& ku band modem

It is vsat connectivity............... every link is coming throughmodem to switch & then going to  fe port of router ...in every remote side.................

every site having same setup.shown in diagram..............we have 40 sites....................... every site having one router & two c& ku band modem...........

In this scenario we have two remote sites (remote  side 1 & remote side 2) which is connecting on IP GATEWAY .

Working style of modem:-

we are using c band modem & ku band modem (supports Rip V2).One end of both the modem is connected to switch & another end is communicating over satellite freq  with hub BASED IP GATEWAY.

I

Requirement

1.If packet is going through wan1 then return path should be wan 1.  If forward path is wan 1 then return path should be wan1. Remote side 1 to remote side 2 communication is given below.

2.Means  remote side 1 cband modem  >>>>>>huB BASED IP GATEWAY ) >>>>then it is going on remote side 2 c band>>>& reverse     should be in the same band means C band....

3. i would like all the video & data traffic translated to c band & in case of primary link  down C band traffic  should be  translated on KU band.

FOR VIDEO & DATA,  PRIMARY BAND IS C BAND & KU BAND IS SECONDARY.

4. In case of voice , i would like all the voice traffic translated to the Ku band  & during primary  link down KU band traffic should be translated on C band.

For voice , KU Band is primary & C band is secondary.

5.C band  is working in star topology  (hub & spoke)& KU band  is working in mesh topology.

And we have 40 sites which is connecting through cband over star topology & same 40 sites are also  connecting tbrough k band over h topology................it is vsat conectivity .......so please provide me better solution

3333
Views
0
Helpful
0
Comments