Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1 IP address, 1 device

After the discovery, my DCR dcontains multiple ip address for a single device.

How do I setup CS so that it grab only one IP address for each device?

1 REPLY
Cisco Employee

Re: 1 IP address, 1 device

What types of devices are exhibiting this?  How are they configured?  Discovery uses the ipAddrTable on devices to resolve duplicates.  Provided the duplicates do not already exist in DCR, Discovery should not be adding them unless they do not support the ipAddrTable, or that table is excluded by an SNMP view.

166
Views
0
Helpful
1
Replies