I have added two cisco 12000 series routers manually to dcr in LMS 3.1
These two routers are having XR ios . only one of these router status changes to kown device but the other router status shows unknown device. no inventory and config collection is happening with these two devices in RME. cisco view is not also able to show the module informations for the touters.
Ifound Show privilege command is not supported by XR ios.
in dfm both the device's status are known.
Please help to add these routers in LMS and manage these .
I suggest you contact the TAC so they can confirm if your RME package repository is consistent. It sounds like there may be problems there. For CiscoView, I'm not surprised that the GSR is not working. As I said, CiscoView support for the 12000 series pre-dates IOS-XR. For the HUM problem, you should start a new thread.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...