Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2511 Terminal server

I'm trying to setup a 2511 as a terminal server. I've connected the ethernet port to the console port of the device I need remote access to. Followed all the steps on this page http://www.cisco.com/en/US/tech/tk801/tk36/technologies_configuration_example09186a008014f8e7.shtml#cs

I've given the loopback a non routable IP (172.22.2.1) and used the same to define my IP host

ip host router 2008 172.22.2.1

but when I telnet from the 2511 using the command telnet 172.22.2.1 2008 it telnets to the 2511 itself and hangs!!! what am I doing wrong?

1 REPLY
Hall of Fame Super Silver

Re: 2511 Terminal server

Uzma

You have posted this same question in the Remote Access forum, where I have posted a response. I suggest that any further discussion be consolidated in the Remote Access forum.

HTH

Rick

267
Views
0
Helpful
1
Replies
CreatePlease to create content