Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2801 Forced to 10 MIPS?

I have to connect to a fiber system with a 2801 that only talks 10 MIPS, and doesn't play nice to negotiate with a 10/100 switch. I need to force the port to 10 MIPS so it can talk.

Can this be done? What do I need to do to accomplish this? I'm a non-network engineer forced to do network stuff for this project.

Mark

Bountiful, Utah

2 REPLIES
Silver

Re: 2801 Forced to 10 MIPS?

In the particular interface you can specifically use the command "speed auto", it will negotiate and match the other end port speed.

New Member

Re: 2801 Forced to 10 MIPS?

You can also go into the interface config and use:

speed 10

This will force it to 10.

99
Views
0
Helpful
2
Replies
CreatePlease to create content