I have a 2811 which I can reach with a normal web browser and configure with hyperterminal. I have downloaded and installed CCP 1.1 but after creating a community and adding the ip of the 2811 it is never discovered. Any ideas?
Normally it will take time to discover. In the Community Information screen, choose the device that you want to work with, and click Discover. Depending on network conditions, Cisco CP may take several minutes to discover the device. If you want to work with additional devices in the community, choose them and click Discover. To begin configuring a discovered device, click on the row for the device, and in the left pane, click Configure then the Configure tree expanded in the left pane.
In the Configure tree choose the configuration task that you want to perform.
Thanks for your reply, I am still having no luck here. When I click on discover after having marked the 2811, the display first indicates "discovery scheduled" and then about 5 seconds later changes to "discovery failed" every time. Any other ideas what I can do to troubleshoot this?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...