Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2950's and http authentication

Hello,

I'm deploying some 2950's with a crypto IOS 12.1.22.EA8a. Here is most of my config (that I think applies to my problem). I'm trying to let a user called "look" log in by http at level 1. However no matter what I've tried using the documents from ciso. I can't get it to work. It always pops up with LEVEL-15 login by default.

------

aaa new-model

aaa authentication login default local

aaa authorization exec default local

username look password 0 xxxxx

username look privilege 1

(I've tried the ip http auth commands as well)

line vty 0 15

password xxxxx

line con 0

password xxxxx

login authentication default

Note the users work fine via SSH or Term.

Thank you for any suggestions.

1 REPLY
Silver

Re: 2950's and http authentication

You can configure username and password pairs, which are locally stored on the switch. These pairs are assigned to lines or interfaces and authenticate each user before that user can access the switch.Refer URL

http://cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a0080648d7f.html#wp1020693

94
Views
0
Helpful
1
Replies