Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

2960 with SNMS 1.5

Hi,

I have 2 catalyst 2960-24TT-L with c2960-lanbase-mz.122-25.SEE2 IOS.

I've installed CiscoWorks SNMS 1.5, but it doesn't find this device as a Cisco device.

what is the problem??

The other devices (WS-C3550-48-EMI, WS-C2950-24) works fine.

2 REPLIES
Cisco Employee

Re: 2960 with SNMS 1.5

The 2960s are not supported by SNMS 1.5. We have stopped producing device updates for that release as the product is end of life.

Cisco Employee

Re: 2960 with SNMS 1.5

Actually, for the 2960s you may be in luck (depending on the sysObjectID). A patch was released about two years ago to address these devices as well as AP1200s for RME 3.5. You will need to install RME 3.5 IDU 13.0, then you can contact the TAC to get the patch for CSCse25066.

The 2960s covered by this patch are:

2960-24TT - 1.3.6.1.4.1.9.1.716

2960-48TT - 1.3.6.1.4.1.9.1.717

2960-24TC - 1.3.6.1.4.1.9.1.694

2960-48TC - 1.3.6.1.4.1.9.1.695

2960-G24TC 1.3.6.1.4.1.9.1.696

146
Views
0
Helpful
2
Replies
CreatePlease to create content