Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

2960s stack lost management connection after auto archive setup

Hello,

We have a problem on a 2960s stack. (2: WS-C2960S-48FPD-L and 2:WS-C2960S-48FPS-L all on IOS: 15.0(2)SE4 ) Yesterday we implemented the following commands on out stack for archiving our config:

Archive
path tftp://10.x.x.70/Backup/SW-MNGT-01/$h-$t
time-period 2880
write-memory
end

After write memory was submitted I lost connection to the stack from tftp server 10.x.x.70.

It's not accessible at all. tested ssh, telnet, ping, http and so on. I have also tried to change to another NIC on this server(same IP address), but that does not help. If I change the IP address on the tftp server everything is OK.

 

Have implemented this setup on several other switches with no problem, but it looks like this is a problem related to stack setup. It's accessible from other IP addresses in this subnet but not from 10.x.x.70.

 

We implemented this on a standalone 2960s and that works.

Suggestions?

Vegard B

 

1 REPLY
Hall of Fame Super Gold

Duplicate post.  Go HERE.

Duplicate post. 

 

Go HERE.

52
Views
0
Helpful
1
Replies
CreatePlease to create content