Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

4500 SNMP Module alarms traps

I am trying to find the correct configuration for when modules from 4500 series devices are removed or fail an SNMP trap will be sent.

So far I can not find any documentation or supporting command that will trigger this.

The command on the 6500 series does not exist on the 4500s.  " snmp-server enable traps module "

Version:

Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASEK9-M), Version 12.2(53)SG, RELEASE SOFTWARE (fc3)

Please help, Thank You!

Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: 4500 SNMP Module alarms traps

I believe you have "snmp-server enable traps fru-ctrl".  That should enable the cefcModuleStatusChange traps which will be sent when a module changes state.

2 REPLIES
Cisco Employee

Re: 4500 SNMP Module alarms traps

I believe you have "snmp-server enable traps fru-ctrl".  That should enable the cefcModuleStatusChange traps which will be sent when a module changes state.

New Member

Re: 4500 SNMP Module alarms traps

Thanks!

The command originally didn't work by itself, but after come changes to the other SNMP configurations the traps were then received.

SNMP configurations below:

Switch#show run | inc snmp

snmp-server community (removed) RW 5

snmp-server trap-source Vlan411

snmp-server chassis-id (Removed)

snmp-server enable traps fru-ctrl

snmp-server enable traps entity

snmp-server enable traps envmon fan temperature

snmp-server host *.*.*.* (Removed)  fru-ctrl envmon

Logging:

Switch#show run | inc log

service timestamps log datetime localtime

logging buffered 16384

logging trap notifications

2593
Views
0
Helpful
2
Replies