Hello! As I see in the devices table, Catalyst 4503 IOS with SupII is not supported by DFM, and VLAN Management in Campus Manager either. Is there or is it planned any patch or update for whole LMS or these applications to get support of this device?
If it is not possible, is there any other solution to achieve fault management with DFM and VLAN management with Campus Manager? Thanks.
The Connectivity setting configures connectivity threshold parameters for network adapters (ports and interfaces). It also controls the analysis of systems that repeatedly restart, triggering an operational exception. For more information about how Device Fault Manager concludes that a system is excessively restarting.
Do you mean that if I try to manage a 4503 sup II IOS with DFM, it will raise a RepeatedRestarts alarm? Does that mean the device appear as 'Known Device'? Could I solve this issue if I disable Connectivity settings.
If I disable Connectivity settings, what other problems are not been monitored?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...