Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6500 & NAM2

I cannot get IP connectivity to my NAM2 after I upgraded a 6500 from a Sup2 with HybridOS to a Sup720 with IOS. The IP address of the NAM2 was in the same subnet at the Sup2 CatOS. Now that CatOS has gone away, I no longer have IP connectivity to the NAM2. There are other active devices in the subnet, and they all work fine. I can do a "session slot 4 processor 1" to connect to the NAM2, which proves the NAM2 is working okay. It's obviously an IP issue. What IP space do I have to put the NAM2 in to make it reachable?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: 6500 & NAM2

You use the command:

analysis module X management-port access-vlan VLAN

To specify the management VLAN of the NAM. However, you may be running into CSCee10005 in which case you need to configure the following on the switch:

fabric switching-mode force bus-mode

1 REPLY
Cisco Employee

Re: 6500 & NAM2

You use the command:

analysis module X management-port access-vlan VLAN

To specify the management VLAN of the NAM. However, you may be running into CSCee10005 in which case you need to configure the following on the switch:

fabric switching-mode force bus-mode

186
Views
0
Helpful
1
Replies