Hello, I am having trouble getting NNM8.10 to "recognise" our two 6509-E set up as a VSS pair. The Device shows as Cisco generic device. Other 6509-E (non VSS) devices are discovered correwctly. All SNMP strings are correct. I'm assuming this is a MIB or OID problem? Does anyone know the specifiv MIB which will correctly identify the device? I'd hate to think I would need to download any install every 6500 MIB!
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...