The customer uses LMS2.6. He had used SNMPv1 for management Cisco devices by the LMS. The funcionality of LMS was OK. He changed the SNMP v1 to SNMPv3 (AuthNoPriv) and some problem with UT occured. Some end devices are not discovered using UT. The switches, where the end devices are connected, are discovered and displayed in the Topology View (the state is green). This behaviour is for different type of switches. These switches are available using SNMPv3. Do you have any idea for solving this problem? Thank you.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.