Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AC power

I am looking at the power specs for a 3945 gateway it shows 540watts is that per power supply or for the unit.  the 3945 gateway and 7845 server both have 2 power cords so just need to know if the specs are for the unit or per power cord/supply.thanks. 

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: AC power

In dual power supply units typically the power specification is for the entire unit. While the two PS's will share the load, both the primary and backup power circuit should be spec'd to handle the enintre load as that is the requirement in the event of the failure of one of the power supplies or AC circuits.

Hope this helps. Please rate helpful posts.

1 REPLY
Hall of Fame Super Silver

Re: AC power

In dual power supply units typically the power specification is for the entire unit. While the two PS's will share the load, both the primary and backup power circuit should be spec'd to handle the enintre load as that is the requirement in the event of the failure of one of the power supplies or AC circuits.

Hope this helps. Please rate helpful posts.

198
Views
0
Helpful
1
Replies