Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Access server

I have a 2511 acting as an access server.  I need to monitor a non-cisco device with console speed of 115200.  All other cisco device work correctly on lines 1-15, I have added it to line 16, but when I connect to it I dont get anything from the console.  When I plug a cisco switch to 16 I dont get anything either.  Not sure if it is setup correctly, but below is my config.  Please help

[code]

ip host h3 2003 10.10.10.10

ip host h1 2001 10.10.10.10

ip host h16 2016 10.10.10.10

line 1 15

exec-timeout 0 0

flush-at-activation

no exec 

transport input telnet

line 16

exec-timeout 0 0

flush-at-activation

no exec

transport input telnet

speed 115200

[/code]

129
Views
0
Helpful
0
Replies
CreatePlease to create content