I am using a PIX 506E version 6.3(5) using 10.0.0.X. We recently installed a voice mail server with the ip address 10.0.0.92 and I set up a static IP map for address 66.x.x.x to allow access from the outside.
My issue is that we have laptops that are sometimes inside and somtimes outside.
Is there a way to use the public IP address (66.x.x.x) inside the local network and route it to the device's ip address (10.0.0.92)?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...