Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Add a device type in LMS2.5.1

Ciscoworks LMS2.5.1 is not able to backup the config of a 4506e. The following error message is generated:

>>>> CM0056 Config fetch failed for <hostname> Cause: CM0204 Could not create DeviceContext for 2762 Cause: CM0206 Could not get the config transport implementation for <IP> Cause: UNKNOWN Action: Check if required device packages are available in RME. Action: Check if protocol is supported by device and required device package is installed. <<<<<

How do i add the 4506e device type to RME?

Thanks!

1 REPLY
Cisco Employee

Re: Add a device type in LMS2.5.1

If you upgrade to LMS 2.6, then to LMS 2.6 SP1 (i.e. RME 4.0.6), then you can download the device package for the 4500-E switches. This package was just released eight days ago. All of these updates are freely available from Cisco.com. Start from http://www.cisco.com/kobayashi/sw-center/cw2000/lan-planner.shtml to get the LMS 2.6 update.

101
Views
0
Helpful
1
Replies
CreatePlease to create content