Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Adding an ASA to LMS

LMS 2.6 / RME 4.0.6

Hi, I have an ASA 5550. I have installed the ASA 2.1 package and have verified that the OID is supported. When I add the device to the DCA the credentials check fails and I get a device not supported message.

Can anyone advise me on how to troubleshoot this?

2 REPLIES
Cisco Employee

Re: Adding an ASA to LMS

Do you have the SNMP RO configured and it matches what you enter in LMS? Do you also have the snmp-server host command added to the ASA which points to the IP address of LMS?

New Member

Re: Adding an ASA to LMS

Hi davistan,

Yes, the snmp settings are on the ASA and in LMS. I can perform an snmp-walk of the ASA from LMS.

Thanks,

Piaras

197
Views
0
Helpful
2
Replies