After Multi server workflow is run server 1 ACS is good, but not server 2

[alukes]

server 1 LMS 3.0.1

server 2 LMS 3.0.0

server setup>summary

ACS summary

server 2 is red

server 1 is green

Operation Summary

Step Configure ACS mode shows both servers as completed and ACS configuration is successful. Both ciscoworks were restarted. I can't get into server 2 at the moment because SSO is turned on and I don't see anything about it on the navigation bar of server 1.

What should I look for to resolve this problem?

Thanks in advance

[alukes]

server 2 only has DFM and CS loaded on it.

server 1 has DFM, CS, RME and CM on it.

Do both servers need to be built the same? If so what are the steps to move the license from one box to the other?

If I use the temporary license, what happens when it expires?