After Multi server workflow is run server 1 ACS is good, but not server 2
server 1 LMS 3.0.1
server 2 LMS 3.0.0
server 2 is red
server 1 is green
Step Configure ACS mode shows both servers as completed and ACS configuration is successful. Both ciscoworks were restarted. I can't get into server 2 at the moment because SSO is turned on and I don't see anything about it on the navigation bar of server 1.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.