Does anyone know if it is possible to alter the threshold in the Alarm Set in Cisco Prime Collab? I added one of our MCUs to CPM and set up an Alarm set below.
I then dialled many endpoints into the MCU to see if I would get an alarm from CPM telling me that the port utilisation were high but I got nothing... I am getting emails telling me a Zone is down on one of our VCS's & emails to tell me an endpoint has de-registered so I know the emails are set up correctly.
So my questions are;
Can I alter the High Utilisation setting to trigger an alarm at say 50% then again at 75%?
Has anyone successfully managed to get CPM to send any alarms in regards to the MCU?
The version of CPM I am using is: Cisco Prime Collaboration Version: 9.5
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...