Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Alerts stuck in DFM

I am using LMS 2.5 / DFM 2.0 , with ~ 160 devices. My problem is that there are some events that remain active although they became obsolete. I tried to rediscover/delete devices, I reinitialized the whole DFM database, but these events continue to appear as active. I am using Ciscoworks on Solaris platform. Is their any way to get rid of these obsolete events ?

3 REPLIES
Silver

Re: Alerts stuck in DFM

You should be able to "Acknowledge" the alarm and then it should go away. Else, the method to remove the alarm is by going into the device that logged the Authentication Failure and then to clear the notice from there. You should be able to go into the Router and then in enable, type "clear log". This will clear the normal events. If the trap is still there, then need to clear the DFM database.

New Member

Re: Alerts stuck in DFM

I have this same problem. Some alerts will just not go away even though the condition has cleared. I have a case open with TAC on this and I am awaiting a resolution. You can reinit the DFM databases to clear these.

New Member

Re: Alerts stuck in DFM

The same problem...

Also - when I start Alerts and activities screen, all alerts have duration 999 hours.When I want to open any of A&A detailed view, screen with empty table apears, I have to wait 2-3 minutes for data to be displayed.

137
Views
3
Helpful
3
Replies