Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ANI database and dbReader

LMS 2.2

When I use dbreader to show tables for ANI database, I get no tables. I do not get an error message, just the header but no tables. What should I be seeing?

Also, where does it store the Campus Manager data, is it in the ANI database?

5 REPLIES
Blue

Re: ANI database and dbReader

username: dba/cmfDBA/cwsiSA (ANI)

db name: rme/cmf/ani

The last pair returns this:

Table Information for database: ani

Name Owner Type

...

EmbuPhoneTracking cwsiSA TABLE

EmbuTrafficParamTmpl cwsiSA TABLE

EmbuUserTracking cwsiSA TABLE

...

New Member

Re: ANI database and dbReader

OK, but how about my second question. What I am trying to do is run validation between what is in RME to what is in Campus Manager(Topology Groups).

Which database holds the Campus Manager (Topology Group Data)?

Blue

Re: ANI database and dbReader

In the same ani db, there're a lot Wbu* groups, including a couple of WbuTopo* groups, but I can't make sense of the data with what I see in the Topology Groups in Campus Manager GUI.

Don't know what kind of validation you're looking to do. As you may be aware, there're a couple of tabs in Server Config -> Setup -> ANI Server Admin, to enable "device synchronization" between RME to Campus Manager.

Red

Re: ANI database and dbReader

Topology Groups are in the cmf database.

New Member

Re: ANI database and dbReader

Yes, we do the sync every night, but we want to be able to run a manual (via excel/access) validation between the hosts in the RME and the host that show up in the ANI/Campus Manager.

190
Views
5
Helpful
5
Replies
CreatePlease login to create content